JUMO Wtrans E01, Operating Manual

Page: 19 / 64

19
3 Preparing the measuring probe
If the batteries were removed or if they must be replaced, proceed as follows:
1. Unscrew screw (A) on the battery compartment cover (B) counterclockwise.
2. Remove the battery compartment cover (B) and battery case (E) from the transmitter. Remove the
battery clip (C) from the battery case (E). Disconnect the internal voltage supply connection (F) and
battery case from the cover (B) for the battery compartment. Remove the used batteries from the
battery case (E).
For the initial startup, the battery case is in the accessories set and not fitted to the measuring probe.
3. To insert the 4 batteries, first move the batteries up/down against the contact spring (D) of the neg-
ative pole and then connect the positive pole (G). Make the sure the polarity (+ and -) is correct!
4. Fit the battery case (E) and voltage supply connection (F) in the cover (B) for the battery compart-
ment. Connect the battery clip (C) with the battery case (E). Insert the cover (B) on the transmitter.
Make sure that the internal voltage supply connection is not damaged by pinching or bending!
5. Tighten the screw (A) clockwise on the battery compartment cover (B) (max. 1 Nm).
6. Fit the antenna (H), see chapter 3.4.1 "Installing the antenna", Page 23.
For the initial startup, the antenna is in the accessories set and not fitted to the measuring probe.
3.2.2 Safety information concerning lithium batteries
 http://battery-e.jumo.info
(B)
(C)
(D)
(G)
(F)
+
+
-
-
(A)
(E)
(H)