JUMO Wtrans E01, Operating Manual

Page: 23 / 64

23
3 Preparing the measuring probe
3.4 Antenna installation
3.4.1 Installing the antenna
1. Screw the antenna (A) clockwise onto the transmitter (max. 1 Nm).
For the initial startup, parts A to E are in the accessories set.
2. Insert O-ring 16 × 2 mm (B) into the recess of the protective cap (lower section) (C).
3. Screw the protective cap (lower section) (C) clockwise onto the transmitter. Make sure the O-ring (B)
is positioned correctly!
4. Insert O-Ring 8 × 1.5 mm (D) onto the antenna and move it all the way down into the recess of the
protective cap (lower section) (C).
5. Screw the protective cap (upper section) (E) clockwise onto the protective cap (lower section) (C).
Manually tighten the protective cap (upper section) (E) onto the knurl so that there is no gap at the
screw connection.
(E)
(C)
(B)
(A)
(D)