JUMO digiLine CR HT10, Operating Manual, Page: 76 / 84

13 Configuration
76
Measuring ranges 1 to 4
Sig. sec. value No signal
Temperature input
Compensation temp.
Uncomp. conductivity
Compens. Conductivity Signal source for the secondary value display
In the measuring mode, the secondary value is shown on the
display as an additional value accompanying the main value
(smaller display below the main value).
The appearance of the display can be set in the display type
(higher up in this table).
Configuration item Selection/setting op-
tion Explanation
Configuration item Selection/setting op-
tion Explanation
Bargraph start Measured value of the main value at the start of the bargraph
display
Bargraph end Measured value of the main value at the end of the bargraph
display
Decimal place XXXX
XXX.x
XX.xx
X.xxx Number of desired decimal places
The number of decimal places can be set from 0 to 3.