JUMO 202580, Installation Instructions Manual

Page: 36 / 82

15 Calibrating CR conductivity sensors
36
15.2.2 Calibration default settings for CR conductivity sensors
Before you can perform a calibration, you must first enter the necessary calibra-
tion default settings. The possible settings for the CR calibration are described
in the following.
Open the calibration default settings:
Device menu
r
Calibration
r
Select CR Analysis Input
r
Calibration Default Settings
The calibration default settings enable the calibration routines to be accessed in
the particular calibration menu.
Calibration routines that are not enabled are not visible in the calibration menu.
Additional calibration default settings are explained in the following table.
NOTE!
The "Calibration Default Settings" menu appears in the Device menu only if a
user with corresponding user rights is logged in.
v
Chapter 8.2.1 "Log-on/Log-out", Page 74
Sample screen:
CR calibration default
settings