CLEANING AND MAINTENANCE
Note: in order to avoid electric shocks, please power-off the
machine and pull out plug before maintenances or repairs.
Cooling mode
1)
2)
3)
4)
When the A/C enters cooling mode automatically or cooling mode is selected
after power ON, the cooling indicator lights up.
Press “ ” or “ ” to adjust temperature (from 16 °Cto 30 °C).
Press “ ” and “ ” simultaneously on control panel or press the button of
remote control“°C/°F” to switch Fahrenheit and Centigrade degree
temperature.
Press “SPEED” to select high / Mid / low fan speed.
Note: when the setting temperature is obvious higher than the current room
temperature, the compressor will stop working, and the fan will continue to
run.
Fan mode
1)
2)
3)
1)
2)
3)
When pressing “MODE” or choosing fan mode by pressing the remote control,
fan mode indicator lights up.
Press “SPEED” to select high / Mid / low fan speed.
Temperature can’t be set.
Dehumidification mode
When pressing “MODE” to select “DRY” mode or choosing dehumidification
mode by pressing the remote control, the dehumidification indicator lights up.
Before select to the “DRY” mode, it must first be removed the water wedge (9),
insert water manifold (include), place the other end of the water manifold into
the water vessel or drainage passage, as shown in the right figure.
After entering the dehumidification mode:
When room temperature
≥
17 °C (62 °F), the compressor is ON.
When room temperature
≤
15 °C (59 °F), the compressor is OFF.
5.
1)
2)
6.
1)
2)
TIMER
When pressing “TIMER” button, the user can be setup the switch ON or OFF
time once the indicate light of “TIMER” lights up.
Under standby state, press “ ” or “ ” to setup the time to switch on from
“1hour to 24 hours”.
Under power - on state, press “ ” or “ ” to setup the time to switch off
from “1hour to 24 hours”.
WATER DRAINAGE
This machine with auto-water-evaporating system. Condensed-water cycle to
cool down the condenser, which will not only improve cooling efficiency, but
also save energy.
If inner water tank is full, “FL” indicator will flash on the screen, machine enter
into standby mode, buzzer shouts, compressor stops and all keys is invalid till
machine recovers to be normal.
Power off the machine: Pull out the water stop and rubber plug to drain out
water, and restart it, the machine will run normally.
4)
5)
When temperature increases to room temperature
≥
17 °C, the compressor is
started again. (in order to protect the compressor, it will be restarted 3min.
later)
Under dehumidifying mode, fan speed is low only.
Temperature can’t be set. (Note: when use dehumidify function, should unlock
the exhaust duct from appliance, otherwise, it will cause worse dehumidify
performance, and appear “FL” water full alarm)
GB
72
|
73
