EN
51
1. Assistance level 1
2. Assistance level 2
3. Assistance level 5
FIG. 6
Battery Indicator
The battery charge is shown on the display
in five levels. FULL is shown at the top of the
battery charge indicator when the battery is
fully charged. When the battery is discharged
(low battery voltage) the letter E is shown at
the bottom of the battery indicator and the
indicator flashes. The battery must then be
charged.
1. Fully charged battery
2. Partially discharged battery
3. Fully discharged battery (the indicator
flashes)
FIG. 7
Error codes
Error codes are shown automatically if there is
a fault in the control electronics. Check the part
of the bike to which the error code refers.
Error code 21: circuit fault
Check that all connections are correct,
undamaged and not short-circuited.
Error code 22: motor control fault
Check that motor’s starter lever is in neutral.
Error code 23: motor circuit fault
Check that motor is correctly connected to the
control unit and that all the connections are
intact.
Error code 24: signal fault hall sensor
for motor
For control unit without hall sensor, check that
motor is correctly connected. For control unit
with hall sensor, check that the hall sensor is
correctly connected.
Error code 25: brake fault
Check that the brakes are not applied, and
have gone fully back before switching the
display unit on.
Error code 30: communication fault
Check that all the cables between the
display unit and the control unit are correctly
connected.
Settings
With the display switched on, press the buttons
+
and
–
at the same time for 2 seconds to go
to the settings menu. To leave the settings
menu, press the button
for 2 seconds.
Setting the wheel diameter
Press the button
+
or
–
to set the correct wheel
diameter. Wheel diameter settings: 16 inch, 18
inch, 20 inch, 22 inch, 24 inch, 26 inch, 700C,
28 inch. The standard setting is 26 inch. Press
the button
to confirm the wheel diameter
setting and to go to the next setting.
FIG. 8
Setting the top speed limit
A top speed limit can be set for the power
assistance as a safety function. The electric
motor switches off when the speed goes
over this limit. The top speed limit can be set
from 12 to 40 km/h. The standard setting is