EN
40
-. The set speed value is used during the next step. 6 audio
prompts are given when the exercise programme is finished and
the equipment stops. After 5 seconds the equipment goes into
standby mode.
Number buttons
The buttons 2.4.6.8.10.12 are used to set the speed.
Quick start
1. Plug the equipment into a power point and insert the safety
key.
2. Press the START button. Three audio prompts are given and
the equipment starts at a speed of 0.8 km/h.
3. Set the required speed with SPEED+ or SPEED-.
Use
1. Press SPEED+ to increase the speed, or SPEED- to reduce
the speed. The speed can also be set with the buttons
2.4.6.8.10.12.
2. The STOP button is used to stop the equipment and to reset
the settings.
3. Your pulse is shown on the Pulse screen if you put your
hands on the pulse sensors on the handles for 5 seconds.
Manual mode
1. Press the START button. The equipment starts at a speed
of 0.8 km/h and all the data is counted up from 0. Set the
required speed with SPEED+ or SPEED-.
2. In standby mode, press the MODE button to go to H-1,
countdown for time. 10:00 flashes on the TIME display.
Set the required value from 5:00 to 99:59 with SPEED+ or
SPEED-.
3. In countdown mode, press the MODE button to go to H-2,
countdown for distance. 1.00 flashes on the DIS (distance)
display. Set the required value from 0.5 to 99.9 with SPEED+
or SPEED-.
4. In countdown mode for distance, press the MODE button
to go to H-3, countdown for calories. 50 flashes on the CAL
(calories) display. Set the required value from 10 to 999 with
SPEED+ or SPEED-.
5. Select one of the three countdown modes and press the
START button. The equipment starts after 3 seconds. Set
the required speed with SPEED+ or SPEED-. Press the STOP
button to switch off the equipment.
Built-in programmes
The equipment has 9 built-in programmes. Press the PROGRAM
button to select a programme P1–P9. Use SPEED+ or SPEED-
to change the set time. Press the START button to start the
programme. Each programme consists of 10 steps and the
time for each step is the preset time/10. An audio prompt is
heard when the equipment goes to the next step. The speed is
changed to the setting for the actual step. You can change the
speed during a step by pressing the buttons SPEED + and SPEED
Summary of Contents for KAYOBA 002-400
