EN
55
using detergent
NOTE:
•
Detergent can only be used in low-pressure mode.
•
The high-pressure washer is not intended to be used together with petroleum-based products.
1.
Take the lid off the chemicals container (diagram 10) and fill with detergent according to the
manufacturer’s instructions. Replace the lid.
2.
Dissolve dirt by applying detergent with the jet set to a wide spray pattern against the dry
surface. Work from below and upwards on vertical surfaces.
3.
Allow the detergent to act for 1 to 2 minutes, but do not allow it to dry.
4.
Rinse off the detergent from the surface from below and upwards.
STORAGE
1.
Switch off the high-pressure washer.
2.
Close the water tap.
3.
Empty the chemicals container.
4.
Relieve the pressure in the high-pressure washer by keeping the trigger pressed until no more
water comes out through the nozzle.
5.
Lock the trigger.
6.
Unplug the power cord.
7.
Treat the high-pressure washer with non-corrosive, non-toxic antifreeze before putting into
winter storage. NOTE: Rinse the high-pressure washer with clean water before using it again.
Antifreeze can damage washed surfaces.
10
Summary of Contents for HAMRON 220-155
Page 58: ......