
EN
11
6. Install the lamp post when the cement
has set.
Assembly
1. Fit the adapter (I) to the upper lamp post
(H) using the screws (M5).
2. Insert the wires for the lamp housing (J)
in the adapter (I) and fit the lamp on the
adapter using the nut (M7) and threaded
pin (M6).
3. Undo the post head (K) and connect the
lamp housing wires and the prepared wire
(not supplied). Connect a brown (L) wire
to brown, yellow/green (earth) to yellow/
green, and a blue wire (N) to blue.
FIG. 2
4. Pass the wires through the upper and
lower lamp post respectively (G) and (D).
Fit the post head (K) on the post using the
screws (M8).
5. Fit the lower part (E) of the lamp post on
the base (D) using the screws (M3).
6. Connect the power cord to the terminal
block and the prepared wire.
7. Fit the base (D) on the anchor rods (B)
using a nut and washer (M1).
8. Adjust the lamp post to the height
required and secure the upper part of the
lamp post using the screw (M3).
Summary of Contents for Anslut
Page 3: ...1 2...