Jula Anslut 007015, Operating Instructions Manual

Page: 34 / 40

EN
34
• A warning that the product must be
stored in a well-ventilated area of at
least the same size as the room in which
the product is intended to be used must
be available.
• Refrigerant circuits must only be opened
and worked on by an authorised
refrigeration technician.
• Service must only be carried out in
accordance with the recommendations
on the manufacturer. Maintenance and/
or repairs that require other qualified
personnel must be carried out under the
supervision of a person competent to
handle flammable refrigerant.
• The product uses flammable refrigerant.
Leakage of refrigerant is a fire risk on
contact with an external source of heat.
• Do not overload the power point or
connection. Risk of electric shock and/or
fire as a result of overheating.
• Do not start/stop the product by
disconnecting/reconnecting the power
supply. Risk of electric shock and/or fire
as a result of overheating.
• Do not use a damaged or unsuitable
power cord. Risk of fire and/or electric
shock.
• Never modify the power cord or plug.
Connect the product to a separate
electric circuit. Risk of electric shock and/
or fire as a result of overheating.
• Do not touch the power cord or the plug
with wet hands. Risk of electric shock.
• Do not place the product near sources of
heat. Plastic parts can melt. Fire hazard.
• Switch off the product immediately and
pull out the plug in the event of any
abnormal noise, smell, smoke or other
sign of a problem. Risk of fire and/or
electric shock.
• All the electrical connections must be
made according to the wiring diagram on
the middle column behind the water
container.
FUSES
• The circuit board has a fuse to provide
protection from overcurrent. The fuse data
is printed on the circuit board, e.g: T 3, 15
A, 250 V (or 350 V).
• Note concerning fluorinated gas
• Fluorinated greenhouse gases are
contained in hermetically sealed products.
For specific information on the type,
amount and carbon dioxide equivalent in
tonnes of fluorinated greenhouse gases
(some models), see marking on product.
• Installation, electrical connection, service,
maintenance and repairs to the product
should be carried out by qualified
personnel.
• Dismantling and waste management
should be carried out by qualified
personnel.
WARNING!
• Never use other objects or methods than
those recommended by the
manufacturer to defrost or clean the
product.
• Store the product in a room without
sources of heat, such as naked flame,
LPG products, electric heaters, etc.
• Do not puncture or burn.
• Note that refrigerant can be odourless.
• The floor area in the room where the
product is installed must be at least 8 m2.
• Follow national regulations concerning
gas.
• Keep the ventilation openings clean and
unblocked.
• The product should be stored in such a
way as to prevent mechanical damage.