18
Combinations
By removing the middle strip
or
and
for smaller cars
+
, the rear seat
cover can be adjusted to the width of the
seat.
Step 12
– Fitting the si
de parts
•
Divide the supplied side parts by
fully opening the zips and
connecting a side part to the base
part (see diagram).
Step 13
– Finishing off
•
Pull the finished parts over the car
seat and fasten the parts under
the seat by pulling the supplied
strap fastener through the rubber
loops. Stretch the strap and tie up.
Step 14
– Fitting the headrest cover
Mark the openings for the headrest holders on the to
p of the cover. Cut small holes in the cover with a
sharp knife and fit the headrest (see also item 8 in these instructions).
MAINTENANCE
Recommendation: Dry-clean, do not tumble dry.