Jula 431-191, Installation Instructions Manual

Page: 34 / 34

ENGLISH
34
F. Fit the position selector (9) onto the bottom of the rod (1).
IMPORTANT! Do not use a pipe wrench for assembly as this damages the surface. Use a 23 mm
spanner.
G. Mark out the holes in the holders (5) on the wall where the rod is to be fitted. Use a ruler and spirit
level. Drill holes, insert plugs and carefully screw the holders to the wall.
IMPORTANT! Before drilling, check that there are no hidden electrical cables, water pipes, etc. that can
be hit by the drill. Use plugs suitable for the wall material. The plugs and screws provided are for solid
concrete/brick walls. Use an appropriate drill for the wall material, with a suitable diameter for the selected
plug.
H. Fit the two hoses (8) and (10). Check that the seals (2) are seated correctly before tightening the
joint.
IMPORTANT! Do not use a pipe wrench for assembly as this damages the surface. Use a 23 mm
spanner.
I. Fit the hand shower (6) on the hose and tighten carefully by hand.
J. Fit the upper, fixed shower head (3) on the rod and tighten carefully by hand.
Settings
Select the upper shower head (4) or hand shower (5) with the position selector (9).
The hand shower can be moved vertically and angled in the holder (7) to the position required.
MAINTENANCE

Clean with a soft, damp cloth and a mild cleaning agent.

Never use petrol, solvents, strong detergents, abrasive cleaners, scouring pads or a wire brush to
clean as these will damage the surface.
Subject to printing errors and design changes over which we have no control. In the event of problems,
please contact our service department.
www.jula.com