ENGLISH
40
Settings
Switch on/Switch off
1. Switch on/Switch off
the unit by pressing
. If the unit is stopped it cannot be restarted within 3
minutes.
2. Press
to increase the temperature. Highest adjustable temperature is 40 °C.
3. Press
to reduce the temperature. Lowest adjustable temperature is 15 °C.
Setting the time
1. Press and hold
for three seconds. A long audio signal is heard and the display shows the hours
setting. Press arrow up/arrow down to set the hours and press
repeat the procedure to set the
minutes. Confirm the settings by once again pressing
.
Timer setting
1. Press
and
hold for six seconds. An audio signal is heard followed by two audio signals indicating
that the hour setting for timer start is activated. Set the time when the unit should start (
flashes).
Press arrow up/arrow down to set the hours and press
repeat the procedure to set the minutes.
The start time for the unit is now set (Timer on). Confirm the settings by once again pressing
.
2. The display shows the setting of hours timer shut-off. Set the time when the unit should stop (
flashes). Press arrow up/arrow down to set the hours and press
repeat the procedure to set the
minutes. The stop time for the unit is now set (Timer off). Confirm the settings by once again pressing
.
3. If everything has been done correctly the symbols below are shown and the timer setting is complete.
4. You can deactivate the timer function by pressing and holding
for six seconds. An audio signal is
heard followed by two audio signals indicating that the timer setting is activated.
5. Press
to confirm the timer function is shut off. The symbols for timer start and timer shut off,
and
, goes out.
Key lock
1. When the unit is connected to voltage, you can activate the key lock by pressing and holding the
buttons
and
for 5 seconds. A long audio signal is heard. Symbol
is flashing. Release
the buttons. Symbol
lights to indicate that all the keys are locked. Repeat to deactivate the key
lock. The padlock symbol goes out.
2. Press and hold
for 3 seconds to switch between showing the temperature in °F and °C.
Parameter settings
1. When the unit is connected to voltage, but switched off, press
to go to parameter settings.
The parameter codes and values are shown on the display. To change the setting, press
. If the value is negative or two-digit this is indicated by the symbol .
2. To approve a setting, wait until the parameter in question goes out and press
. The unit
leaves parameter setting mode within 10 seconds. The DATA symbol goes out and the TEMP
symbol comes on.
