24
Replacing the planing bit
Always wear gloves when replacing planing bits.
The planing bits for this machine are reversible.
To replace or invert a planing bit: Use the
supplied spanner (accessory). Unscrew the three
screws in the bit retainer. Now remove the bit
retainer from the cutter and pull out the planing
bit from the side. Push the new, or reversed,
planing bit into the bit retainer from the side.
Now press the retainer as far as it goes into the
cutter and centre the bit. Screw tight the three
screws in the bit retainer so that it sits firmly in
place.
MAINTENANCE
Make sure the plug is disconnected from the mains supply before cleaning the machine. Wipe the casing
with a dry, soft cloth. The planing bit on this machine becomes worn in time. Continuous use of a blunt or
damaged planing bit will reduce the performance of the machine and can overload the electric motor.
Check the planing bit regularly.
Replacing the drive belt
After a long period of use the drive belt can slip off the drive shaft, or may even break. If the planing bit no
longer rotates when the motor is running this is probably what has happened. To replace the belt, open
the left side of the planer with a Phillips screwdriver. Now remove the belt by lifting it with a large
screwdriver, while turning the drive shaft a few turns. Put the new belt on the small wheel first and then on
the large one, while turning it a few turns. Contact our customer service if you have problems replacing
the drive belt.
