– 13 –
4) Fix the air tube using cable clip
9
supplied with
the machine as accessories. (For the setscrew,
use setscrew
!0
fixing the motor cover.)
8
!1
Connector
CN1
Air tube
1-A
Connector
CN2
Air tube
1-B
Air tube
2-A
Air tube
2-B
9
!0
5) Install air tubes coming from the machine head
and the cords coming from the control box to
the position as shown in the figure. At this time,
be careful of the number and alphabet of the
air tubes and the cords. (Adjust the alphabet
of the air tubes to the alphabet of the solenoid
valve. Also, adjust the figures to the figures of
the connector label.)
6) Connect solenoid valve asm.
8
and the
regulator
1
using long air tube supplied
!1
as
accessories.
When the cable sags, fix it to the
table using the staple supplied
with the machine as accessories.
3-15. Installing the air hose (Pneumatic type only)
1
2
Close
Open
1) Connecting the air hose
Connect the air hose to the regulator .
2) Adjustment of air pressure
Open air cock
1
, pull up and turn air
adjustment knob
2
and adjust so that air
pressure indicates 0.35 to 0.4 MPa (Max. 0.55
MPa). Then lower the knob and fix it.
* Close air cock
1
to expel air.
