19
5.1.4. Door Seal
The door seal should be cleaned regularly with clean water without detergents, and then wiped dry with a soft cloth. Please make sure
that the cabinet door close properly after cleaning. To check the state of the door seal place a sheet of paper between the seal and the cabinet
body and close the door. When you try to pull out the paper, you should feel moderate resistance.
5.1.5. Other Terms and Conditions
Metal parts of the equipment can corrode in case of improper use and maintenance. To prevent corrosion of the metal parts, please:
• Do not use any cleaning agents that contain chlorine and sodium of different types as they can damage the protective layer and parts of
the unit (including different types of stainless steel).
• During cleaning and maintenance of the equipment, please make sure not to damage the data plate of the unit. The data plate contains
useful product-specific data.
6. FAULT IDENTIFICATION AND REPAIR
In case of any problems during the startup of the equipment or its operation, it is necessary to return to those sections of the service
manual that explain their operations. This aims to ensure that the device is properly operated. If you still experience difficulties, the following
hints will help you solve the problem.
The equipment does not work:
Make sure that:
• The device is connected to an electrical power supply
• Voltage and frequency in the network corresponds to those recommended by the manufacturer 220 V / 50 Hz
• The main switch is turned on
• The controller is switched on
Water leakage under the device or into the chamber:
Make sure that:
• Verify the correctness of device levelling
• Verify the patency of outlet hoses
• Empty the condensate tray or container
Damage to the power cord:
• In case of damage to the power cord in order to avoid danger its replacement must be carried out by a manufacturer, service department
or similarly qualified personnel. In case of power cord replacement by unauthorized persons
WARRANTY CAN BE VOIDED!
The device is operating, the lighting is switched off...
Make sure that: