JUDO HEIFI-TOP
7
Installation
4.1.1 Requirements for the place of
installation
The room where the unit is installed must
be dry and frost free!
Unauthorised persons must not have
access to the filter!
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
–
In order to be able to safely discharge
the wastewater in operation and in case
of any defects that occur in the system,
precise compliance with the details
given in the “Installation” chapter is nec-
essary! If the wastewater (backwashing)
cannot be safely and completely dis-
charged, the house and installations can
be damaged by water.
–
A shut-off valve must be installed up-
stream and downstream of the filter! This
enables the water supply to the filter to
be interrupted during installation, servic-
ing/maintenance, repairs and in case of
malfunctions. Floods and serious water
damage to house installations can there-
fore be avoided.
4.1.2 Installed position
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
Always install the filter in a vertical position
(± 5°)!
4.1.3 Mounting the built-in rotary
flanges
Install using the supplied built-in rotary
flange. The built-in rotary flange is used as a
connecting element between the pipe and
the filter.
The built-in rotary flange is suitable both for
horizontal and vertical pipes.
It is suitable for both horizontal and vertical
pipes.
The built-in rotary flange must be in-
stalled in the direction of flow. This is
marked by a cast in arrow.
Failure to comply with this means that back-
washing is impossible. By and by this leads
to an increasing pressure loss.
It must be ensured that no backflow pre-
venter, gravity brake or any other automatic
shut-off device is installed between the filter
and the expansion vessel.
If this is not observed, backwashing is not
possible as no backwashing water is avail-
able.
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
The flange surface of the built-in rotary
flange must be in a horizontal position! The
built-in rotary flange must be fitted so that
mechanical stresses cannot occur! Other-
wise mechanical damage can result in the
built-in rotary flange. Otherwise mechanical
damage can result, the pipe may burst or the
built-in rotary flange can break. This can
result in major water damage.
In this case, people close to the filter are ex-
posed to a health risk due to the large quan-
tities of water.
Therefore, during installation, ensure that no
large forces act on the pipe, built-in rotary
flange and filter.
