Blender with Glass Jug
Assembly
Use
2. The Lid is a push-fit into
the top of the Jug .
3. Lower the assembled Jug onto
the Motor Body . Turn clockwise
until the Jug locks into place.
•
NOTE: the appliance will not
operate until assembled correctly.
•
BEFORE FIRST USE: wash
assembled Jug and Lid in warm
soapy water, rinse and dry.
•
Ensure that the appliance is
disconnected from the electricity
supply before assembly.
1. The Measuring Cup pushes
into the Lid Pouring Hole - turn
the Measuring Cup clockwise
to positively lock into place.
•
The appliance should be sited on a
dry, level and stable surface,
away from direct heat.
1. With the appliance switched OFF
( Position 0) add ingredients to
the Jug by removing the lid .
2. When you have added your
ingredients to the Jug , push the
Lid securely back into position.
3. Stabilise the appliance by placing
one hand on top of the Lid
(with the Measuring Cup /
Pouring Hole Cover fitted)
4. For best results begin blending
by pressing the Pulse Button
two or three times, allowing the
ingredient pieces to drop to the
bottom of the Jug between bursts.
5. Food may then be further
blended by using the Operating
Switch in position 1 (low
speed) or 2 (high speed).
•
The Lid must always be
attached to the Jug while
the appliance is operating.
•
Ingredients may also be added
to the Jug while the appliance
is operating ( Position 1/2)
by removing the Pouring Hole
Cover from the Lid .
Removing processed food
•
Before removing food from the
Jug , wait until the Cutter Blades
have stopped spinning.
1. Disconnect the appliance
from the electricity supply.
2. Remove the Lid .
3. Pour food from the Jug
, scraping contents down with
a spatula if necessary.
•
To remove foods of a more solid
consistency, remove the Jug
from the Cutter Blade Assembly
(Take Care - Sharp Blades)
and Jug Base . Scrape food
from the Jug with a spatula.
