JTS UF-20TB/5, Instruction Manual

Page: 18 / 40

18
English
3) Press the button  to go to the setting
Set
& Power
, i e the muting function is not
locked
4) After selection, use the button SET to go to the
line
Lock OFF
The line indicates
ON/OFF
5) Press the button  to activate the key lock
(ON)
6) Press the button SET to save the setting
When a button is pressed, the following message
appears:
Press Set
for 2 Sec.
to unlock
keypad.
When the switch MUTE (8) is used while
ALL
is
selected, the following message appears:
Lock ALL
Mute
function is
disabled.
Notes:
1 When the key lock is activated and the menu is
deactivated, the symbol appears on the display
2 The key lock can also be activated or deactivated di-
rectly on the receivers UF-20R/5 and UF-20S/5 via
the REMOSET function (refer to the instruction manual
of the receivers)
– Deactivating the lock –
1) Keep the button SET pressed for two seconds
until the menu
KeyLock
appears
KeyLock
ALL
Lock ON
Fig. 17
2) Press the button SET once again so that
ON/
OFF
appears in the lower line
3) Press the button  to select the setting
OFF
and press the button SET to save the setting
4 Specifications
Carrier frequency range: 530 – 605 MHz
Frequency stability: ±0 005 %
Transmission power (EIRP)
Low: 10 mW
High: 50 mW
REMOSET frequency: 2 4 GHz
Audio frequency range: 50 – 18 000 Hz
Low-cut filter: 100 Hz, 18 dB/octave
Ambient temperature: 0 – 40 °C
Power supply: 2 (rech ) batteries
of size AA
Operating time: > 20 h with
3400 mAh rech bat-
teries
Dimensions : 62 × 170 × 23 mm
Weight: 90 g
Microphone connection: 4-pole mini XLR jack
2
4
1
3
Fig. 18 Microphone jack
1 = ground
2 = 5 V operating voltage for the microphone
3 = signal input
4 = impedance correction
Subject to technical modification
All rights reserved by MONACOR
®
INTERNATIONAL GmbH & Co KG No part of this instruction manual may be
reproduced in any form or by any means for any commercial use