User Manual
5
800.321.6221
GuestCall Paging, IQ Pagers
Model Number: J1705, J1706
Range Test
Turning this feature on and walking around with your pagers will give you an idea of the range of your transmitter.
Transmitter will send a signal to the pagers for this range test. Pagers will light up each time that the pagers receive
the message from the transmitter.
When testing range, use 3 pagers to ensure that you have the most accurate reading. When you have reached a point
where ALL 3 pagers do not receive 2 consecutive pages then you are out of range.
Performing Range Test
>
Scroll to RANGE TEST.
>
Press ENTER key. Transmitter will send page to all pagers every 10 seconds.
Smart Charger Re-Programming
With the Smart Charger, you can renumber pagers back into sequential order as well as ensure that all pagers have the same
configuration.
Program Pagers
The pagers will be set to the programming applied prior to shipping as well as renumbering the pagers into sequential order.
>
First position, indicated by the location with the
, will be renumbered to the number shown on the charger’s display.
>
Pagers will renumber based on their position in the charger.
>
To activate the programming cycle.
o
PRESS and HOLD the PROG button on the charger for eight (8) seconds.
o
Charger will beep twice indicating that the cycle has begun.
o
You will see the pagers perform several functions as it applies each of the pager configurations. When the
process is complete, all pagers will be in sequential order.
>
NOTE: Replacements for lost pages will arrive with the number 888 on the display.
Replacement of Lost Pagers
Replacements for lost pagers will arrive with the number
8 8 8
on the display.
>
Place new pagers into the charger in any location EXCEPT position #1 and use the PROG function listed above to have
them work with your existing system.
