If an exam is in memory when the console is turned on, Commander activates in
“Review” mode . From this point you can review exam data, change to “Test” mode
to finish testing, or delete the exam .
Setup Mode
Testing Defaults
The Commander console enables you to use the “Setup” mode to control a variety
of test parameters, such as the testing threshold, number of tests, number of repe-
titions per test, and force readings in pounds or newtons . Once test parameters are
set, they become the defaults for the console . For example, if you set the number of
repetitions to three, then the unit will test for three repetitions per side for every
exam, unless you change the default . Default settings do not change when the unit
is turned off or when an exam is deleted . Defaults can only be reset manually .
Setting Defaults
Three buttons are used when setting console defaults: TEST CONT . (SETUP), NEXT
(SELECT) and REVIEW (CHANGE) . The buttons function as follows:
TEST CONT. (SETUP): Press this button to move through the console modes until
“Setup” is displayed . It is also used to exit “Setup” after setting parameters .
NEXT (SELECT): Use this button to advance through the test parameters .
REVIEW (CHANGE): This button changes the parameter setting .
Press this button until console
is in “Setup” mode. After
parameters are set, use this
button to exit back to “Test”
mode.
While in “Setup” mode, use
this button to advance through
parameters.
When a parameter is displayed,
use this button to change the
default setting.
6
