H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Presses\AP-K2\TS009-02 AP-K2 Operation Manual.doc
17
6. CRIMPING MACHINE
MAINTENANCE
CAUTION
Disconnect the Power Cable from the
mains supply before carrying out any
maintenance operations on the Crimping
Press.
6-1. Lubrication
MAIN SHAFT BEARING
Lightly grease the main-shaft bearing once a year using
a general purpose grease, eg Castrol LM.
RAM SECTION
Remove the cap head socket screws from the ram cover
and add a few drops of machine oil to the felt pads in the
three oiling holes once a week.
CLUTCH SECTION
Remove the cap head socket screws from the belt-cover
catch and open the cover.
Add a few drops of oil to the oiling points indicated on the
photograph.
NOTE: The frequency of lubrication is dependent on
the use of the machine. Do not apply excessive
lubrication because the oil may drip through onto
the applicator
and contaminate the terminals.
ROLLER CLUTCH
Step 1
Slowly rotate the fly-wheel whilst pulling the V-belts to the
side to remove them.
CAUTION
ENSURE
THAT
FINGERS
DO
NOT
BECOME
TRAPPED BETWEEN THE V-BELT AND THE
FLY-WHEEL
Step 2
With the aid of a pair of internal circlip pliers, remove the
circlip retaining the fly-wheel.
MAIN SHAFT BEARING GREASING
LOCATION
RAM SECTION OILING LOCATIONS
CLUTCH SECTION OILING LOCATIONS