background image

4

25

SYSTEM FEATURES

Four-Button

Remotely start your car to run the heater or air

Extended Range

conditioning from an extended distance.

Remote Control

Keyless Entry

Remotely locks and unlocks your power door locks.

Trunk Release

Remotely opens your trunk with a push of a
button. (Optional part #775 required)

Remote Programmable

Remotely program your vehicle to run 5 to 15

Run Time

minutes.

Run Time

Lets you check the run time that the unit is

Confirmation

programmed for.

Tach/Tachless

A programmable feature that lets you choose from the

Option

easy to install tachless operation or the standard
wire-in, tach operation.

Parking Light

Confirms that your vehicle has received a remote

Confirmation

signal and will remain on if the engine is remotely
started.

Dome Light

Never walk up to a dark vehicle again. When unlocking

Supervision

the vehicles doors by remote control the dome light 

will

come 

on and stay on for 1 minute, or until you activate the ignition
switch. (Optional part #775 required)

Cold Start 

Remotely program your car to start at a preset
temperature. Automatically starts your car in freezing
temperature so you never have a dead battery.

Pit Stop Mode

Allows you to exit the vehicle while the engine
remains running.

Extended Range

Allows you to operate your system from up to 400 feet

Antenna

away. (800 feet for E Models)

Code Learning

Allows your remote starter to learn new remotes, 
should you want to add remotes, or if remotes are lost.

Limited Lifetime 

Guarantees life-long protection.

Warranty

ATTENTION:

We urge you to immediately place this card in your wallet.

OPERATING FUNCTIONS
FOR YOUR WALLET OR GLOVE BOX

1-800-878-8007

www.jbstech.com

MADE IN AMERICA, GUARANTEED FOREVER

Starting with the Remote Transmitter Press and release button #1. The parking lights
will flash once, confirming the car starter received the signal. The car will then start
and the parking lights will remain on while the vehicle is running. To shut off the
engine before the preset time, press button #4 or press the brake pedal. NOTE: If your
car does not start on the first crank it will automatically attempt to start 2 more
times (in tachless mode). While in tachless mode, parking lights will wait approximately
10 seconds before turning on. Pit Stop: Exiting the Car with the Engine Running Make
sure the transmission is in park and press button #1 before turning the ignition switch
off. Keyless Entry Operation Press button #2, the parking lights will flash once and
the doors will lock. Press button #2 again, the parking lights will flash twice, the
doors will unlock, and the parking lights will remain on for one minute or until you
turn the ignition on or press the brake. Dome Light Option (optional) The dome light
will remain on for one minute or until you turn the ignition on or press the brake.
Trunk Release Output Optional output modules are available to do one of the following:
open the trunk, roll up the windows, close the sun roof etc. This output will pulse
.75 seconds when pressed and released. In instances where a continuous signal is needed
such as sun roof and power windows, hold down button #3 as long as the signal is needed.
The parking lights will remain on as long as this button is being pressed. Runtime
Confirmation Press and release Button #4. The parking lights will begin to flash. Each flash equals
5 mnutes of runtime.

Summary of Contents for INSTALLATION GUIDE















Reviews: