50
Suspend Mode
When the system enters the Suspend mode, the CPU and onboard peripherals will be shut off.
HDD Power Down
This is selectable only when the Power Management field is set to User Define. When the
system enters the HDD Power Down mode according to the power saving time selected, the hard
disk drive will be powered down while all other devices remain active.
Soft-Off by PWR-BTTN
This field allows you to select the method of powering off your system.
Delay 4 Sec. Regardless of whether the Power Management function is enabled or disabled,
if the power button is pushed and released in less than 4 sec, the system enters
the Suspend mode. The purpose of this function is to prevent the system from
powering off in case you accidentally “hit” or pushed the power button. Push
and release again in less than 4 sec to restore. Pushing the power button for
more than 4 seconds will power off the system.
Instant-Off
Pressing and then releasing the power button at once will immediately power
off your system.
Resume on PCI Event
Enabled
This field should be set to Enabled only if your PCI card such as LAN card or
modem card uses the PCI PME (Power Management Event) signal to remotely
wake up the system. Access to the LAN card or PCI card will cause the system
to wake up. Refer to the card’s documentation for more information.
Disabled
The system will not wake up despite access to the PCI card.
Resume On LAN
If you are using a LAN card that supports the remote wake up function, set this field to
Enabled. The will allow the network to remotely wake up a Soft Power Down (Soft-Off) PC.
However, if your system is in the Suspend mode, you can wake up the system only through an IRQ
or DMA interrupt. Refer to “Wake-On-LAN Connector” in chapter 2 for more information.
USB KB WakeUp From S3(S4)
This field, when enabled, allows you to use a USB keyboard or USB mouse to wake up a
system that is in the S3 (STR -Suspend To RAM) state. This can be configured only if the “ACPI
Suspend Type” field is set to “S3(STR)”.
Resume By Alarm
Enabled
When Enabled, you can set the date and time you would like the Soft Power
Down (Soft-Off) PC to power-on in the “Date (of Month) Alarm” and “Time
(hh:mm:ss) Alarm” fields. However, if the system is being accessed by
incoming calls or the network (Resume On Ring/LAN) prior to the date and
time set in these fields, the system will give priority to the incoming calls or
network.
Disabled
Disables the automatic power-on function. (default)
