JRI Nano SPY, User Manual

Page: 7 / 13

©JRI 7
VI.
BATTERY REPLACEMENT
Removing the battery
Open the battery cover

with a suitable
object (coin) to align the marks
(/!\0 = Open ; 1= Closed)
Remove the battery

from its lodging
Replacing the battery
Put the new battery

in place respecting
the polarity

.
Battery detection is confirmed by the
activation of the red LED

for few seconds. The device can be activated after the extinction of the red LED.
*Recommended batteries: Saft LS14500 type AA 3.6V 2250mAh
VII. MAINTENANCE
Clean the device with a soft cloth, either dry or slightly moistened with water. To remove stubborn dust,
use a cloth soaked in a diluted, non-abrasive detergent. Then wipe carefully with a soft dry cloth.
Never use benzene, thinner, alcohol or any type of solvent, which can cause discoloration or deformation
of the surfaces.
VIII. TECHNICAL FEATURES
a) Common features:
HMI : 1 RGB LED + 1 sensitive bouton
Frequency band : 2.4GHz (from 2400 to 2483.5 MHz)
Maximum Radio Power
: 10 dBm
Memory : 10 000 timestamped measures
Resolution : 0.01
Dimensions : 63 mm x 42 mm x 25 mm
Case : Polycarbonate – Food Contact
Power
: 3,6v Lithium battery up to 6 years life time battery,
depending on usage
Weight : ~ 60g
b) Specific features:
Nano SPY T1 Temperature (internal probe)
Sensor
: PT100 sensitive element inside unit
Operating range : -40+85°C
Measurement range : -40+85°C
Accuracy, standard version
: ±0.4°C from -20°C to +40°C / ± 0.5°C outside this range
IP rating : IP 68
Frequency of measurement and
transmission : adjustable from 1 min to 12h
Frequency of recording
: adjustable from 1 min to 24h
Response time : ~ 5 min. to 90% of the variation
KEEP THE BATTERY AWAY FROM FIRE; DO NOT ATTEMPT TO RECHARGE OR SHORT-CIRCUIT IT
ONLY USE BATTERIES* SUPPLIED BY JRI (REF : 11596)



