JRI Nano SPY, User Manual

Page: 3 / 13

©JRI 3
I.
INTRODUCTION
The Nano SPY is a measuring device for 1 or 2 physical parameters (T or TH depending on the model). Data is
transmitted through NANO Link or Relay/Alarm modules using wireless 2.4GHz radio signal to the JRI-MySirius
monitoring software hosted on the JRI could or the customer’s server.
The Nano SPY complies with EN 12830 with temperature probes only, and is compatible
with EN 13486 which defines procedures for periodic verification.
a) Product contents
•
1 Nano SPY
•
1 User guide
b) Symbols
Do not use the device under conditions other than those described in the technical
characteristics
Risk of fire or explosion in the case of improper use:
- Recharging of the battery
- Short circuiting of the battery
If the device is used in a manner not specified by the manufacturer, the protection
provided by the device may be compromised.
II. INSTALLATION RECOMMANDATIONS
To ensure optimal radio transmission, a certain number of recommendations must be respected, as any
wireless transmission is subject to disturbances.
a) Sources of disturbances or attenuation
• The presence of obstacles in the wave path between the Nano SPY and the Nano SPY Link (wall,
furniture, people…) or near the antenna.
• The thickness of an obstacle in the wave path. The attenuation is greater diagonally than
perpendicularly.
RECYCLING: do not dispose of in a refuse dump or waste disposal bin. Comply with existing legislation for disposal.
Power source: this device is powered by a 3.6VDC type AA lithium battery (§ ch. V).
CE LABELING: this device is certified to conform to European regulations for electrical safety, flammability, disruptive
electromagnetic emissions, and immunity to environmental electrical disturbances.
FCC ID : W45 12525
This device complies with part 15 of the FCC rules. Operation is subject to the following two condition:
1. This device may not harmful interference,
2. This device must accept any interference received, including interference that may cause undesired operation.
The grantee is not responsible for any changes or modification not expressly approved by the party responsible for compliance.
Such modifications could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.