©JRI
4
A solid metal wall will not allow transmission by radio. A perforated metal wall will allow waves
to pass while attenuating them.
b)
Positioning
The Nano SPY ALARM must be installed at height near the Nano SPY recorders and the Nano SPY
LINK (<40m, less than 3 m from a power outlet if this option is used (mains / USB transformer)
and at more than 20cm from the passage of a person.
Ethernet Version:
Provide for the presence of an Ethernet socket on an ADSL access point or on a company network
less than 3 meters from the Nano SPY LINK.
Ensure that the port 13251 is open on your internet box (refer to the manual of your ADSL box
for its configuration) or verify this with your IT service provider.
The
network
must
be
programmed
in
DHCP
and
accept
DNS
requests.
WiFi Version
Ensure that you are in a zone of WiFi coverage.
To ensure your safety during installation or an intervention on a device placed in a high
position, use proper equipment which is in good condition and provides adequate
stability, wear appropriate, non-slip shoes and install warning signs around the work
area if the intervention takes place in an area of foot traffic.
III.
PRESENTATION
a)
Control unit
b)
Connection
Batterie 3,6VDC
730mAh (3xAAA)
Alarm relay
output
Service connector/
external power
Battery
connection
30VDC / 1A
Status LED
Rear cover /
mounting support
bracket
Ethernet socket
Absent on WiFi version
Bouton sensitif
Mounting holes
(2 on each side)
Reset
Blocking by screw
Light band
Alarm indicator
Identification stamp
on the bottom side
