JRC JSS-296 -, Service Manual

Page: 48 / 220

3.6.7 Adjusting the Printing Pressure (to Printing Paper Thickness)
The printing pressure can be adjusted with the head adjust lever located on the right side of the inner
part of the printer.
CAUTION
Be sure to turn OFF the printer power when opening and closing the printer cover.
Failure to comply could result in electrical shock, failure, or injury.
Just after printing, the temperature of the printer head is high. Do not touch the printer head
until the temperature goes down.
Failure to comply could result in a burn or injury.
Do not touch any part of the cutter. Doing so may result in injury.
Procedure
1. Open the printer cover and set up the head adjusting lever.
Each type of paper should be set as follows:
Normal paper : The optimal position among the numbers shown is
③
.
Three layers of copying paper : The optimum position is
⑤
or
⑥
.
Note
・
The printing pressure increases in numerical order (
①→⑥
).
・
To open/close the printer cover, refer to 3.6.4.
44