JRC JFV-130HP Series, Installation Manual

Page: 35 / 60

34
(2) Cable Routing
Re-route the power cable and transducer cable so that they may not interfere with the
cable from an affected equipment.
Make sure that sufficient space is provided between these cables and the coaxial ca-
ble from the radio equipment.
As VSWR of the radio equipment antenna is increased, its coaxial cable tends to pick
up more noise. Be sure to provide a skirt for the antenna of 27 MHz DSB radio
equipment.
(3) Grounding Cable
Improper grounding can cause noise troubles. Make sure that the system is positively
grounded with the copper plate.
When two or more copper plates are spliced, the effect you can expect will be signifi-
cantly limited. When splicing is unavoidable, they shall be solder connected.
(4) NMEA Cable
The NMEA cable can also be a noise source. Route the NMEA cable through the
clamp filter, then wrap is around the filter a single turn.
The clamp filter used is ZCAT2032-0930 (for small diameter) or ZCAT3035-1330 (for
large diameter) from TDK Co.
ｸﾗﾝﾌﾟﾌｨﾙﾀ
１ｔ ｹｰﾌﾞﾙを巻く
Clamp
filter
A single turn on the clamp filter