30
The following activation and setup procedure should be used for all JR PCM10, 10S, 10SX, 10SxII, and 10X systems.
Prior to activating the CCPM function, it is first suggested that a data reset function be performed to reset the desired model number to be used back
to the factory default settings.
Caution:
Prior to performing the data reset function, it will be necessary to select the desired model number to be used. Access the model select func-
tion (code 84) and select the desired model to be used.
A) Data Reset
Access the data reset function (code 28) once the correct model number has been
established. Next, press the
Clear
key to reset the current model. Press the
Enter
key to exit the data reset function.
B) CCPM Activation
Access the swash type function (code 65). Next, press the
SEL
key until “3 servos (120°)”
appear on the screen. Once this is complete, it will be necessary to change the value of the
aileron, elevator, and pitch function from the factory default settings using the + and - keys
below the pitch value. Press
Enter
to exit the swash type function.
C) Servo Reversing
Access the servo reversing function (code 11). Next, reverse channels 1, 2, and 4 by pressing
the desired channel number. The screen should appear as shown. Press
Enter
to exit the servo
reversing function.
D) Travel Adjust
Access the travel adjust function (code 12) and adjust the servo travel values as shown. Please note that the required travel values will vary
based on the type of servo selected. Press
Enter
to exit the travel adjust function.
Note:
The travel values shown for the rudder function are for use with Piezo type gyros, like the JR NEJ-400, or NEJ-450 type gyros. If a
conventional mechanical type gyro is used (JR 120, 130 etc.), then the travel value of the rudder channel will need to be reduced to
approximately 100%.
CCPM SOFTWARE ACTIVATION AND INITIAL ADJUSTMENT (CONTINUED)
3. JR 10 SERIES SYSTEMS
SETUP PROCEDURE
[DATA RESET]
MODEL 1
SPCM
CLEAR
ENTER
[SWASH TYPE]
3SERVOS(120•)
FXP
AILE
ELEV
PITCH
[NH
-50%
-50%
+50%
ENTER
SEL
ACT
+
–
CL
+
–
CL
+
–
CL
[REVERSE SW]
REVERSE
NORMAL
ENTER
1
2
3
4
5
6
7
8
9
10
[TRAVEL ADJUST]
THRO
AILE
ELEV
RUDD
H100%
L120%
D120%
L85%
L100%
R120%
U120%
R85%
PAGE
+
–
CL
+
–
CL
+
–
CL
+
–
CL
[TRAVELADJUST]
PITCH
+120%
-120%
+
–
CL
+
–
CL
[TRAVEL ADJUST]
THRO
AILE
ELEV
RUDD
H100%
L100%
D100%
L70%
L100%
R100%
U100%
R70%
PAGE
+
–
CL
+
–
CL
+
–
CL
+
–
CL
[TRAVEL ADJUST]
PITCH
+100%
-100%
+
–
CL
+
–
CL
+
–
CL
[CLEAR]
Select 3 Servos(120°)
digital servos/super servos
Standard servos
