JR ProPo XG11, Operation Manual

Page: 88 / 124

86
▋ Telemetry▋System【TELEMETRY】
▋ ▋ Function▋Explanation
This allows confirmation of the telemetry sensors present in a particular aircraft, gathering
information such as Receiver Voltage, Altitude, Temperature or Propeller or rotor blade r.p.m.,
etc. In addition to the data on the display, alarms are used, so as aircraft conditions can be
monitored without taking your eyes off the aircraft.
Telemetry sensor data value can be displayed on the SUB INFO screen.
Refer to the Page 24 "Sub information screen"
▋ ▋ Setting▋Method
▋ ▋ Receiver▋battery▋(RX-BATT)▋/▋
▋No▋Link▋Alarm▋(NO▋LINK▋ALARM)
⿟ Receiver battery alarm
This function alerts to a drop in receiver battery voltage.
Initially it is inhibited. To activate, set the alarm Voltage
between 3.0V – 9.0V in 0.1V increments.
⿟ No Link Alarm
This will warn when the transmitter is no longer receiving
data from the model. Initially it is set as inhibited. Set the
delay after which the alarm should sound to either 10S
(10 seconds), 15S (15 seconds), 20S (20 seconds), 30s (30
seconds).
▋ ▋ Temperature▋(TEMPERATURE)
⿟ Unit (SCALE)
This selects the units for temperature display - Celcius (°C)
or Farenheit (°F). Select the units as desired.
⿟ Alarm (ALARM)
This sets the temperature at which the alarm will sound
– between 30 and 500°C. Initially this alarm is inhibited.
Set the temperature to the desired alarm point.
▋ ▋ Revolutions▋Per▋Minute▋(RPM)
⿟ Gear Ratio by magnetic sensor
By setting the gear ratio, the transmitter can display
actual final rpm even if the sensor is installed prior to the
final output gear stage. Refer to your aircraft manual to
confirm the gear ratio. Initially it is set as “INH” (inhibit).
Input the necessary value (1.00 to 20.00) in 0.01 steps.
For example
If used on a gas (or nitro) powered Helicopter, it is
possible to obtain main rotor blade RPM by installing the magnetic sensor on the clutch bell, and calculating
rotor RPM using the gear ratio. On an electric helicopter, it is advisable to install the magnetic sensor on the
main gear and directly measure rotor blade RPM (gear ratio 1.00).
⿟ Propeller RPM by optical sensor
It is possible to monitor Propeller RPM by setting the number of propeller blades.
※ For DMSS Module
System▋List▋
DANGER
CAUTION
Helicopter
Airplane
Glider
WARNING
Sub INFO display
F Pack screen
Sub Selection Screen
SUB INFO SCREEN
Sub INFO display
F Pack screen
Sub Selection Screen
SUB INFO SCREEN
Sub INFO display
F Pack screen
Sub Selection Screen
SUB INFO SCREEN
Sub INFO display
F Pack screen
Sub Selection Screen
SUB INFO SCREEN