☆ Trasmitter Setup For The JR PCM9X Ⅱ
JR-CCPM plays a critical role in coordinating the simultaneous activating of multiple servos to control
the swashplate. Activation of just a single servo would not lead to control of the swashplate - the three
swashplate servos must be controlled in a coordinated fashion. The setup of these servos differs from that for
other control functions which control just one servo (for example, the throttle). The initial settings given here
must be confirmed on the bench, and then fine tuned after test flying the helicopter. Prior to commencing this
process, confirm all the trim levers and trim knobs on the transmitter are in their neutral (zero) positions. Also
shift all switches to position “0” (switches moved away from the operator). Please also be familiar with the
instructions for the trasmitter. The initial settings can be entered into the transmitter without turning power on
to the receiver.
Please note that fine adjustment will be needed after test flying the helicopter.
1、Initializing the Radio
① While pressing the【ENT】key (located at the lower
left of the transmitter), turn on the power switch.
(System setting mode,List screen displayed)
② Turn the dial on the right side of the transmitter
to select [Model SEL] and press the dial twice.
③ Turn the dial to select the model number you want
to reset, and press the dial again.
④【Press the【LIST】key to return to [SYSTEM M.].
⑤ Turn the dial to select [MDL Reset] and press.
⑥ Press the【CLR】key and press “YES” in the YES
／ NO confirmation screen.
2、Selecting the Swash Type
① Press the【LIST】key to return to「SYSTEM M.」
again.
② Turn the dial to select「SWASH TYP」and press.
③ Turn the dial again to select [3s120° ] and press.
④ Press the【LIST】key to return to「SYSTEM M.」
⑤ Press the【ENT】key twice to return to the regular
screen.
①「ENTER」+「ON」
②・③・⑤
⑥
④
⑤
①・④
②・③
選択
P.5
Select the model to be reset
Summary of Contents for DSX12
Page 1: ......
Page 2: ...RADIO SETTING MANUAL...
