☆ Transmitter Setup For The JR DSX12
JR-CCPM plays a critical role in coordinating the simultaneous activating of multiple servos to contorl
the swashplate. Activation of just a single servo would not lead to control of the swashplate - the three
swashplate servos must be controlled in a coordinated fashion. The setup of these servos differs from that for
other control functions which control just one servo (for example, the throttle).
The initial settings given here must be confirmed on the bench, and then fine tuned after test flying the
helicopter. Prior to commencing this process, confirm all the trim levers and trim knowbs on the transmitter
are in their neutral (zero) positions. Also shift all switches to position”0” (switches moved away from the
operator).
Please also be familiar with the instructions for the transmitter. The initial settings can be entered into the
transmitter without turning power on to the receiver. Please note that fine adjustment will be needed after test
flying the helicopter.
1、Initializing the Radio
① Press (and hold) the 【ENT】key located on the
lower left of the Transmitter,then turn on the power
switch.
([System Mode List], List screen displayed)
② Turn the dial on the right side of the Transmitter to
select [84.Model SEL] and press.
③ Turn the dial to select ［Model］and press.
④ Turn the dial to select the model number you want
to reset and press the dial again to settle it.
⑤ Use the 【LIST】key to return to”System Mode List”
⑥ Turn the dial to select[28.MDL Reset]and press.
⑦ Press the【CLR】key and press “YES” in the YES/
NO confirmation screen.
⑧ Press the【LIST】key to return to ［Syetem Mode
List］
To switch［Select］and［Copy］press the dial alternately
Select［Model SEL］
①【ENT】+【ON】
Turn the dial to select
Select the model to be reset.
Press the function key to reset
⑦
⑦
⑤・⑧
②・③
④・⑥
P.2
Summary of Contents for DSX12
Page 1: ......
Page 2: ...RADIO SETTING MANUAL...
