![JPT YDFLP LM1 Series User Manual Download Page 16](http://html1.mh-extra.com/html/jpt/ydflp-lm1-series/ydflp-lm1-series_user-manual_2028059016.webp)
YDFLP-C-30-M7-S-X user manual
File Number: EFLP001-B
Shenzhen JPT Opto -Electronics Co. Ltd.
Version :B Date:2020. 8
14
DB25 Pin2, Pin3, Pin22 are not only used to control basic function, but also pulse width.
Table 10
Fiber laser pulse width control pin and signal
Pin#
Item
Description
2
Serial Input
Fiber laser serial input, setting data bits synchronize with
serial clock rising edge.
3
Serial Clock
Serial digital clock, 8kHz
≦
Clock Frequency
≦
10kHz,
10KHZ is recommended.
22
Enable
Pulse width control function:
High: Enable,Pin2 and Pin3 to control the pulse width
Low or Not connection: Disable
3.3.2 Pulse width control instruction structure
1) Control system send the serial input instruction to fiber laser through Pin2, meanwhile send
the clock signal through Pin3. Instruction description will be transmit in binary system, and
first transmit the most significant bit.
2
)
Fiber laser instruction structure as below
:
3
)
OxA5(A5h) is the data transmission activated byte of activated pulse width control interface,
OxA5 and all data byte is transmit to Pin2 serial input.
The data length is 4 bytes.
The first byte of instruction code is 0x01.
The fiber laser will be at high level status at least 10us in advance before changing “Enable”
at any connector, and will be at low level status at least 10us after all change finished.
All instruction design start with 0xA5 byte
4
)
Please set up low Pin19 before use the extend configuration.
3.3.3 Pulse width control instruction code
0xA5
Instruction Code