NXU-2B Operations Manual
2-2
Plainly, mark with indelible ink all mailing documents as follows:
GOODS RETURNED FOR REPAIR
Mark all sides of the package:
FRAGILE - ELECTRONIC EQUIPMENT
Inspect the package prior to shipment to be sure it is properly marked and securely wrapped.
2.4
Installation Overview
NOTE: NXU-2B installation requires knowledge of Ethernet network fundamentals
as well as a basic understanding of Internet Protocol (IP). As with any network-
connected device, improperly configuring and installing the NXU-2B could disrupt
proper network operation. Please seek the assistance of your network administrator
or other knowledgeable person if you are unsure about how your network is
configured.
The following six steps are needed to properly install the NXU-2B:
1.
Determine the IP address, subnet mask, and (if applicable) the gateway address for the
unit. You may have to contact the network administrator for your organization to obtain
this information.
2.
Provide the proper primary power for the unit.
3.
Interconnect the unit with the communications system via the NXU-2B's rear panel
connectors. The rear panel Audio/Control jack provides the lines necessary to interface
the NXU-2B to your audio equipment.
4.
Configure the unit’s operational parameters per Sections 3.2 through 3.5.
5.
Connect the unit to your Ethernet network.
6.
Optimize the input and output audio levels per Section 4.4.2.
The NXU-2B is then ready to use.
Summary of Contents for NXU-2B
