23
Install the motor
PEGASUS / TYPICAL / JOYEE
(3)用開口扳手將襯套固定，再用六
Fix the bushing with the open wrench and
tighten it slightly with the hex wrench.
角扳手將螺絲輕輕帶緊。
(4) 鎖固後，請將兩顆無頭螺絲鎖緊。
Fasten two screws after fixed.
鎖進
Locked
1
鎖固
Fixed
2
1
2
(B)組裝襯套
(1)將襯套溝槽對齊軸心溝槽。
Install the bushing
Aim the trench at bushing and
axle center.
將襯套溝槽對齊軸心溝槽
Aim the trench at bushing and
axle center.
(2)請先 輕鎖 螺絲，並依照順序鎖固螺絲。
Fasten the screw slightly and following steps to
1
2
輕鎖
輕鎖
尖尾
Fasten slightly
fasten screws.
Fasten slightly
Fixed screw
M800、M700
MX5204、GN2000
EX5214
平尾
Flat screw
JY-B804、JY-B805
此為一次性零件
This is disposable part.
當拆下馬達維修時，馬達裝回前須更換新塑膠鋼C型環。
Replace new POM C ring on motor after remove the motor for maintenance.
※注意:安裝時開口方向朝內
※Caution: the gap toward inside when instal
