Jovy Systems® Limited
User Manual
UM1501SLD01
Revision
1.00
Date
August 2015
Page | 11
When the upgrade is successfully complete , a message will appear confirming
that the Firmware update process is complete.
5.
Sleep mode
When the
i
Solder-40 controller senses no usage for 5 minutes, the
i
Solder-40
starts the sleep mode for saving power.
The indicator of this mode is a flashing red led
(short on; short off)
.
To get out from sleep mode and turn to operating mode, move the hand piece
from the holder and wait until the iControl automatically senses and update the
status from Sleep to Operating mode.
6.
Power saving mode*
After 15 minutes in the sleep mode, the
i
Solder-40 will turn to the power saving
mode, where no power is delivered to the tip at all and the tip temperature drops
down to room temperature.
The power saving mode is a safety mode where the device can get out of it by
moving the hand piece to left or right direction.
Also to shift from operating mode switch Off/On the
i
Solder-40
