Mounting parallel bench srew mountingsystem
17
15 a )
15 b )
16 )
17 )
15: Attach the second collector (measurement A = measurement B as
shown in Figure 13b).
Please use the mounting jig (15b).
16: Rotate the clamping piece by 90° (see figure 14) and screw it tight
using a long socket wrench
17: With clashing mounting rails, insert and position the mounting part
in the upper mounting rail
A bottom panel spacer needs to be in-
serted in middle of every second panel to
maintain the correct separation distance
at the bottom of all collectors.
The right and left hand side of the outer
collectors are held in place using the outer
clips. The outer clips are held to the profile
using bolts similar to the middle clamp.
Mounting parallel bench srew mountingsystem
18
18 )
19 )
20 )
18: Attach additional clamping pieces / collectors as described in
Points 13 - 17
19: Attach the mounting part on the upper left and right end of
the collector field
Sequence: mounting rail - hammer-head bolt - mounting part -
washer - nut
20: Screw the collectors into place with the proper torque
Mounting parallel bench srew mountingsystem
15
10 )
11 )
12a )
12 b )
10: Push the clamping piece extension halfway into the inner groove of
the mounting rails (upper and lower) and tighten
Sequence: mounting rail - clamping piece extension - washer - nut
11: Insert the following mounting rails (upper and lower) and attach
them using the clamping piece extension
Sequence: mounting rail - clamping piece extension - washer - nut
12: Attach the mounting rails (upper and lower) using the mounting
part/clamping piece extension (as described in Point 7)
Sequence: mounting rail - hammer-head bolt - mounting part -
washer - nut
Mounting parallel bench srew mountingsystem
15
10 )
11 )
12a )
12 b )
10: Push the clamping piece extension halfway into the inner groove of
the mounting rails (upper and lower) and tighten
Sequence: mounting rail - clamping piece extension - washer - nut
11: Insert the following mounting rails (upper and lower) and attach
them using the clamping piece extension
Sequence: mounting rail - clamping piece extension - washer - nut
12: Attach the mounting rails (upper and lower) using the mounting
part/clamping piece extension (as described in Point 7)
Sequence: mounting rail - hammer-head bolt - mounting part -
washer - nut
When collecting mounting profiles together
a connection piece like this is used to en-
sure that all the profiles are at the same
level.
19
NAVITAS
installation manual
