joule JPSH01, Quick Start Manual

Page: 5 / 12

5
EN
GENERAL INFO
Model JPSH01 (white), JPSH02 (black), JPSH03 (silver), JPSH04 (gold), JPSH05 (green)
Specification
1
Wi-Fi (IEEE 802.11b/g/n, 2.4 GHz), 18.2 dBm max (~66 mW), supply voltage: 220-230 VAC, 50 Hz,
input current: 3.0 A, nominal power: 600.0 W to 700.0 W (≤1 W in standby mode), heating area of
up to 24 m
2
(depends on the room insulation), temperature sensor, tilt sensor
Casing IP44 Protection Class, heat-emitting panel (tempered glass), control unit (PC plastic). Dimensions:
1000×165×412 mm (floor installation), or 1000×34×356 mm (wall mounting)
Functions
2
Climate control, panel temperature control (up to 120 °С), manual and remote control, current
protection, voltage protection and overheating protection, voice assistants, LED indication of
statuses
Scope of
supply Joule Eco Smart Heater, legs (2 pcs.), mounting brackets (2 pcs.), wrench (1 pc.), dowels (4 pcs.),
screws (4 pcs.), nuts (4 pcs.), washers (4 pcs.), Quick Start Guide, Warranty Card
Warranty 1 year (Service life: 2 years)
LED INDICATOR STATUSES
Blue Blue
Reset to factory settings The heating mode is on
Indicator is on The heating mode is off
Green Green
Indicator is blinking The device is overheated
Indicator is blinking 3 times
Red Red
The device is connected to the power source
The device is activated in the mobile app
Purple Yellow
The device is in the Wi-Fi pairing mode
The maintained room temperature mode is on
POWER BUTTON FUNCTIONS
Press and hold the power button:

For less than 3 seconds to turn the heater on or off;
 For 4 to 9 seconds to switch the heater to the Wi-Fi pairing mode;

For more than 10 seconds to reset the heater to the factory settings.
COMPONENTS AND ACCESSORIES (See Figure A)
Power button
❶
, control unit
❷
, heat-emitting panel
❸
, mounting brackets
❹
, power cord
❺
, legs (for floor
installation)
❻
, nuts and washers
❼
, temperature sensor
❽
, screws with dowels (for wall mounting)
❾
, wrench
❿
.
INSTALLATION AND CONFIGURATION
3
1. Unpack the heater and place it on a clean, horizontal surface with its heat-emitting panel facing down.
2. Install the heater as follows:
a. Floor installation (See Figure B) :
NOTE. Only horizontal installation is possible.
 Screw legs
❻
to the back of the heat-emitting panel using nuts and washers
❼
;
 Make sure that nuts are securely tightened and that legs are correctly oriented relative to the device body.
b. Wall mounting (See Figure C) :
NOTE. Horizontal or vertical wall mounting is possible.

Screw mounting brackets ❹ to the rear surface of the heat-emitting panel using nuts and washers ❼ ;
 Attach the hole drilling template (i.e. the carton insert that is available inside the packaging) to the wall; then
drill holes, insert dowels and tighten screws;
NOTE. Provided screws and dowels are suitable for reinforced concrete walls only.
 Lean the heater carefully against the wall and hang it on 2 or 4 screws (See complete user manual
3
).
 Make sure that the device is securely fixed, and that it is free from dust and dirt. Please adjust the screwing
depth, if necessary.