16
Side panel, broad: catalogue no: 51012082 -
breadth 120mm, height 775mm (packs of 2).
The broad and narrow side panels can be combined to give a
total breadth of 180mm, which may also be mounted at an
angle if necessary.
Assembly of the aluminium panel (fig. 11)
• The
bracket
(A)
is fitted onto the side walls of the fireplace
with plugs and screws.
•
Press the side panel
(B)
into the bracket. First put some mortar
on the base of the fireplace behind the panel, as a support.
• If you combine the narrow and broad panels, the angle
towards the side wall of the fireplace can only be max. 70°.
8.4 Enamelled front panels (fig. 12)
Narrow side -
Catalogue no. 51012119 (2 units of 35x573mm)
Broad side -
Catalogue no. 51012118 (2 units of 103x573)
• Remove the front (see relevant section on:
Service
).
• Attach
the
panels
(A)
with countersunk head screws through
the 2 slits at the sides of the combustion chamber. Make
sure that the panels are parallel, ie: equally far from the side
borders and level with the ends of the front panel narrow
top, if that has been installed.
• Put the front in place.
• Narrow top - Catalogue no. 51012121 (703x103mm)
• Broad top - Catalogue no. 51012120 (838x103mm)
•
Screw the two clasps
(C)
to the panel with M6x10mm screws.
•
Place the panel so that it lies on the inside of the front frame.
Tighten the clasps with M6x20mm screws and nuts on the
brackets for insert’s heat shield.
8.5 Ash compartment
cat. no. 51012053 (fig. 13)
• Remove the internal screw in the middle of the bottom of
the combustion chamber so that the fire plate and the cross
bar can be removed.
• Lay a gasket
(B)
(enclosed in the box) along the edge of the
hole.
• Lower the ash pail mantle
(C)
down through the bottom of
the combustion chamber.
•
Lock the ash pail mantle with 4 plate screws from the inside.
•
Fasten the heat shield to the floor
(fig. 4-A)
under the bottom
of the ash pail mantle with M6x10mm screws and nuts.
•
Put the ash compartment
(D)
into position in the mantle.
NB!
The side which does not have a lip is placed against the back
wall.
• Lay the fire grate
(E)
in place in the combustion chamber.
8.6 Fire screen
Classic
: Cat. No. 50012886
Harmony : Cat. No. 50012910
Panorama : Cat. No. 50012910
When the fireplace is being used with the doors open, always
use a fire screen. It can be put in place with two claws at the
bottom end and a spring clip which is pressed into the opening
of the door at the top.
8.7 Self-closing door mechanism
(Panorama)
Adjusting the door mechanism (fig. 14)
•
When adjusting/dismounting, the spring must be set tighter
or looser if the door is too hard or to easy to close.
• First loosen the adjustment screw
(A)
. Use universal tool
(B)
or similar tool and tighten the spring by turning the screw
at the top of the shaft
(C)
clockwise.
• Keep the spring under tension while the adjustment screw
is tightened again.
• The spring tension may be reduced with time and will then
have to be adjusted again.
ENGLISH
