Jøtul I 80 Maxi Classic, Installation And Operating Instructions Manual

Page: 5 / 16

32
Fitting the bottom frame (fig. 5) (Jøtul I
80
Mini/
Maxi - Harmony and Panorama)
1. Remove the knob on the bar for the lower air vent
(fig. 5A)
.
2. Place the bottom frame
(B)
so that the bar passes through
the hole in the frame.
3. Fasten the bottom frame with 2 screws (C) M6x12.
4. Refit the knob.
Ash lip
Place the ash lip next to the bottom frame.
Ash moulding/log stopper
Put the ash moulding into place in the columns situated on the
bottom of the sides between the front and side burn plates.
Assembly of the flue connecting pipe (fig. 6)
1. The flue connecting pipe (A) , which is packed in the box, is
placed on the top of the fireplace. Place the flue connecting
pipe in such a manner that the screw attached to it, is facing
outwards.
1. Place one clamp iron
(B)
on each side. These are held in place
with a screw (C) M8x30mm and with nuts.
4.7 Set up/installation
The product is heavy! Make sure you have assistance when
erecting and installing the fireplace.
Assembly of the chimney (fig. 7)
1. Carry out a trial mount of the insert prior to making a hole
in the chimney. See
fig. 1
for distances.
2. The insert may be assembled with either an Ø150mm or an
Ø175mm flue pipe. This should be 2,3 mm thick - enamelled.
NB! Standard flues of 1mm thickness should not be used. The
supplier can deliver 100
o special bends which are adapted to
the insert.
3. The flue pipe bend should be assembled directly onto the
insert and should be able to rotate 360 o . Pipe Ø150 mm is
assembled on the inside of the smoke outlet and the Ø175
mm is assembled on the outside.
4. Adapt the flue pipe’s length with an overlap of 40 mm, both
in the flue pipe bend and in the chimney collar.
5. Guide the adapted flue pipe into the chimney collar. Attach it
and pull the pipe back into the flue bend. (Use the enclosed
rope seal).
6. Place the insert into its final position. With the aid of a furnace
cement (or possibly some rope seal), the flue pipe bend is
placed in the insert’s smoke outlet.
7. The flue pipe must be attached to the smoke outlet at the
front edge with an M6 self cutting screw
(7A)
. Use an Ø5,5 mm
drill and make a hole in the flue pipe for the screw.
NB! It is important that the joints/flue pipes are completely
sealed. Air leakage etc. may lead to malfunction.
4.8 Control of functions (fig. 8)
When the product is set up, always check the control functions.
These shall move easily and function satisfactorily.
Ignition ventilator (A)
Pushed in = closed.
Pulled out = open.
Top draught (B)
Left position = closed.
Right position = fully open.
Door lock - Mini/Maxi - Classic and Harmony (C)
Place the handle in the groove on the right hand door and turn it
upwards. Open and close the left door in the same way.
Door lock - Panorama
Place the handle in the groove on the door and turn it
upwards.
Damper (D)
Damper is accessory - (if equipped)
Pushed in = open.
Pulled out = closed.
ENGLISH