3
INSTALLATION INSTRUCTIONS
Before installing this product, make sure it complies with your request and that it suits your application!
1.1 Unpack the unit and visually inspect for any transport damage incurred after leaving our factory.
1.2 Depressurise the system before installation or maintenance is carried out!
1.3 Locate a suitable condensate draining point on your compressed air system and connect your valve using a 22mm
wrench. Connect the outlet to an oil/water separator.
- Make sure the arrow on the valve body complies with the flow direction of the condensate.
- Do not use the valve shaft as lever!
1.4 Slide the coil on to the valve shaft and screw on the top nut. Make sure the gaskets are placed properly to ensure
IP65 rating. Place the timer gasket over the coil connection pins.
Make sure there is no debris between the gasket and the coil.
1.5 Mount the timer on to the coil as illustrated, you can mount the timer up-right or upside-down.
1.6 Remove the protection cap from the connector and connect your power cable to the connector as illustrated.
Close the connector and tighten the bottom nut firmly.
1.7 Place the connector gasket on the connector, place the connector on the timer as illustrated and tighten
the screw (max. torque 1Nm). Make sure both gaskets are secured properly to ensure IP65 rating.
1.8 After double checking that the power supply corresponds with the voltage specified on the coil and falls within the
range specified on the back of the timer, you can switch the power supply ON.
1.9 Slowly open the ball valve to restore normal system pressure.
1.10 Press the TEST button to check the valve function. Adjust the PRESSURE and CAPACITY buttons to suit your system.
1.11 Your drain is ready for operation!
Note: We advise to check this product at least once a year and replace serviceable parts when necessary.
Note: Clean the strainer periodically to avoid possible blocking causes by rust and/or debris.
Note: Check the valve function periodically. A purging sound must be heard.
