![Jonsered ST2261e Operator'S Manual Download Page 20](http://html1.mh-extra.com/html/jonsered/st2261e/st2261e_operators-manual_2026488020.webp)
To remove the auger belt
1. Remove the 5/16'' bolts (A) and the lower ¼" bolts
(B) from the 2 sides of the frame assembly. Do not
discard the bolts.
B
C
A
2. Loosen but do not remove the lower 5/16" bolts (C)
on the 2 sides of the frame assembly.
3. Remove the auger belt from the engine pulley.
4. Tilt the rear section down. The front section is tilted
forward at the same time. The bottom bolt (C) is a
hinge between the front and rear sections.
5. Put a wooden block below the hinge point to set the
product in the tilted position.
6. Move the auger belt tensioner arm and remove the
auger belt from around the arm.
To install the auger belt
1. Move the belt tensioner arm and put the auger belt
around and in the groove of the auger pulley.
CAUTION Make sure that the belt is not
caught between the frame and auger
housing as you put the unit together.
2. Remove the wooden block from below the product.
3. Lift the handle to tilt the rear section up. The front
section will tilt back and pivot to attach the rear
section.
4. Make sure that the belt is put in the auger pulley
groove correctly.
5. Install the 5/16'' bolts (A), (C) and tighten (8-12
Ft.Lbs / 11-16 Nm).
B
C
A
6. Install the ¼'' bolts (B) and tighten (4-6 Ft.Lbs / 5-8
Nm).
7. Install the auger belt on the engine pulley. Make sure
that the belt is put correctly around the idler pulley
and installed correctly in the engine pulley groove.
8. Operate all controls to make sure that the auger belt
is installed correctly and that all components are
moving correctly.
To remove the wheels
1. Remove the wheel pin (A) and the retainer pin (B).
2. Remove the wheel from the axle (C).
A
B
C
To clean the product
• Clean plastic parts with a clean and dry cloth.
• Do not use a high pressure washer to clean the
product.
• Do not flush water directly on the motor.
• Use a brush to remove leaves, grass and dirt.
20
797 - 001 -
Summary of Contents for ST2261e
