Warning:
Before connecting the device to the power supply, make sure that the operating voltage indicated on the
product, meets your power source voltage.
Power supply scheme
Remote control (C) uses one 3V
–
CR2025 type battery. When you want to put the battery in follow these rules:
1.
Open the lid of the battery compartment, that is in the back side of the remote.
2.
Remove the protective plastic film insert enclosed between lid and inner part of the battery
compartment.
3.
Insert a new lithium battery as shown in the instructions on the back of the remote. Carefully check that
the polarity of the batteries match the polarity of the contacts in the battery compartment.
4.
Close battery compartment.
5.
Remote control is ready for use.
When the battery is exhausted, remove it from the remote control and change to a new one following the same
rules.
Warning:
Do not leave exhausted battery in the remote control. Do not throw batteries into the fire, trash container, etc.
Collect the exhausted batteries and take them to the battery collection point.
Advice:
If you are not using the product for longer periods of time, remove battery from the remote control.
Usage
Magic light sandbox is meant for play, drawing and therapy spheres. It can also be used as a night lamp or light
effect.
To switch on the ML sandbox
, connect it as indicated in chapter “Connection”. Then point the remote control
eye (it is at the top of the remote) to the center of ML sandbox and push the button ON.
Brightening Darkening
OFF
ON
(+)
(-)
Red
Green
Navy
blue
White
Coral
Green
(light)
Blue
(dark)
Fast jumpy
colours (
FLASH
)
Orange
(dark)
Cyan
Violet
Fade in & fade
out (
STROBE
)
Orange
(light)
Sky blue
Purple
Evenly devolve
colours (
FADE
)
Yellow
(light)
Blue
Pink
RGB colours
change
(
SMOOTH
)
Look at the grey field on the remote control that includes buttons of 16 colours. Push the one you like and the
table will illuminate that colour. To change the colour, simply push the other colour button.