8
TRANSAXLE DRIVE ADJUSTMENT
DISCONNECT
spark plug wire before servicing unit.
DECREASE
INCREASE
1.
Disconnect spark plug wire.
2.
Adjustments to cable tension are made at the barrel entering the Drive
Control Levers.
3.
Adjust cable tension by tightening or loosening cable adjustment barrel
on rear of engine base .
4.
Reconnect spark plug wire.
Belt Routing Diagram
(Top View of Machine)
Blade Drive Belt (with Transaxle
Belt not Shown)
LOOKING THROUGH TOP
Transaxle Drive Belt
(Seated below drive belt on
clutch)
NOTE
:
Moving the cable adjustment barrel OUT increases tension. Moving the barrel IN decreases tension. Increasing the tension too
much will cause the drive to stay engaged whereas not enough will cause it not to engage
when the lever is pulled.
