ENGLISH
42
Apply several layers of Gelcoat with a bristle brush until you
achieve the depth required and then leave for at least six
hours.Then rub with sandpaper dampened in water, with grit
from 200 up to 1,000, then apply abrasive slurry to the surface
and polish, then finish with a layer of boat wax.
Any cracks or oil grooves in the Gelcoat seen
around the stern mirror are caused by normal motor wear and do
not constitute structural damage or construction defects, but are
simply attributable to the level of Gelcoat elasticity, which may vary
depending on climatic conditions at the time the original painting
was done during the construction phase.
Repairs to small cracks/splits
clean the area as described above and mix a small amount of
filler with the activator in the manner indicated by the
supplier.Apply the paste to the crack with the help of a flat-
ended spatula/knife, so that it is uniform with the area to be
repaired; wait for the filler to harden, which takes about two
hours.Then polish with fine sandpaper and touch up with
Gelcoat to finish, as described above.
3
ATTENTION
Summary of Contents for Clubman 24
Page 1: ...JOKER BOAT Srl OWNER S MANUAL english...
Page 2: ...2...