Surface Technology
Oberflächentechnik
Surface Technology
Oberflächentechnik
3
3
Safety instructions
This device has been built according to the latest technical standards and generally accepted
safety regulations. Nevertheless, it can constitute a hazard to the device itself or other equip-
ment during use.
1.
Only use the device if in perfect working order and for its intended purpose. You must
always pay attention to the instruction manual and safety instructions therein and be
aware of the risks! Repair any faults which could affect the device’s safety immediately
by yourself or have these repaired.
The unit is designed exclusively for grinding, milling and polishing with the tools listed
and approved in the joke catalogue. Any other use will be deemed to be contrary to its
intended purpose. The manufacturer cannot be held liable for any resulting damages.
The risk is borne solely by the user.
Correct use also includes compliance with the instruction manual and an observation of
the care and maintenance conditions.
2.
Keep the instruction manual handy at the device’s place of use.
3.
Pay attention to and observe generally applicable statutory and otherwise binding regu-
lations relating to accident prevention and environmental protection in addition to the
information provided in the instruction manual!
4.
All personnel commissioned to work on or with the device must have read this instruc-
tion manual, and particularly the safety instructions chapter, before starting work. This
applies especially for personnel who only work with the device occasionally.
5.
Stop the device immediately should you notice changes to the device or its operating
behaviour that are relevant to its safety. Have these remedied before restarting work.
6.
Do not carry out any modifications, additions or conversions to the device! This also
applies to the installation and adjustment of safety equipment.
7.
Spare parts must meet the technical requirements specified by the manufacturer. This
can only be guaranteed with original joke spare parts.
8.
Any work on/with the device may only be carried out by qualified, appropriately trained
and authorised personnel. Pay attention to minimum statutory age limits!
9.
Wear safety goggles when working with the handpiece.
10.
Personnel undergoing training or in a general apprenticeship should only be allowed to
work with the machine under the constant supervi¬sion of an experienced operator!
11.
Restrain from any type of work that could jeopardise your safety.
12.
The device may only be used if all protective and safety equipment is in place and in
proper working order.
