Surface Technology
Oberflächentechnik
i
!
i
i
9
Trial run
The first time the motor system is started
1. Let the flexible shaft hang down.
2. Press the foot control and leave the unit to run for approx. 10 min at the medium speed.
The resulting high rise in temperature of the flexible shaft is normal!
Before restarting the jokeFlex units after repairs, please pay attention to the following instruc-
tions:
1. Hang the motor in a sufficiently stable holder.
We recommend our suspension devices Article No. 0 020 100 , see also our catalogue „Surface
Finishing“.
2. Then screw the cap over the shaft - motor connection hand tight.
3. The flexible shaft should be run for at least 10 minutes with a slight bend at medium speed
with no load while the motor is suspended.
3. Place foot control (7.3/3) beneath the work-
ing area on the floor and connect motor
connecting lead with compact plug (7.3/2) to
the foot control.
4. Plug mains lead (7.3/1) into socket with
earthing contact - the jokeFlex Premium Plus
motor system is now ready for use.
Figure 7.3 Assembly (Symbolic drawing)
This is important so that the grease on the inner shaft is distributed evenly over the entire sur-
face. The flexible shaft may warm up slightly when running in the jokeFlex motor system. This
does not affect the functionality.
The jokeFlex Premium Plus motor system is fully ready for use after running in.
If you have any questions or encounter problems with our tools please feel free to call our ser-
vice department at any time under:
Tel: +49 (0) 22 04 / 8 39 - 0
Fax:+49 (0) 22 04 / 8 39 - 60
