7
8
7. After placing the base on the
vehicle seat, extend the load leg to
floor
9
, When the load leg
indicator shows green means it is
installed correctly, red means it is
installed incorrectly.
9
-1
!
The load leg has 24 positions.
When the load leg indicator
shows red this means the load
leg is in the wrong position.
!
Make sure the load leg is in full
contact with the vehicle floor
pan.
!
Squeeze the load leg releasing
button, then shorten the load leg
upwards.
The completely assembled base is
shown as
10
!
The ISOFIX connectors must be
attached and locked onto the
ISOFIX anchor points.
10
-1
!
The load leg must be installed
correctly with green indicator.
10
-2
8. Push the infant carrier module
down into the base
11
, if the
infant child restraint is secure, the
infant child restraint indicator
shows green.
12
8
1
7
2
1
9
1
3.
If base used previously with
i-Venture seat remove rebound bar
as shown in illustration
5
!
Store safely for future use with
i-Venture seat.
6
4. Press the ISOFIX release button on
either side of the base, then pull
out the ISOFIX connectors.
7
5. Line up the ISOFIX connectors with
the ISOFIX guides, and then click
both ISOFIX connectors into the
ISOFIX anchor points.
8
!
Check to make sure the base is
securely installed by pulling on
the both ISOFIX connectors.
6. There are 9 adjustable positions for
ISOFIX. Press the ISOFIX release
button and push the base back
against the vehicle seat until tight.
10
1
2
11
12
5
2
1
1
6