7
8
see images
11
-
12
1. The enhanced child restraint is delivered with removable side
impact protection pod. This side impact protection pod MUST be
used on the door side of the vehicle. Installation shown in
11
.
2. Press the release button to remove side impact protection pod.
12
Use Side Impact Protection
Height Adjustment
for Head Support and Shoulder Harnesses
see images
13
-
14
1. Please adjust the head support and check if the shoulder harnesses
are at the correct height according to
13
&
14
!
The shoulder harness height must be even with or just below the top
of child’s shoulders.
13
Lift up the head support adjustment lever, meanwhile pull up or down
the head support until it snaps into one of the 8 positions. The head
support positions are shown as
14
.
see images
15
-
16
Squeeze the recline adjustment button to adjust the enhanced child
restraint to the proper position.
15
Adjust the seat recline to any of the 8 recline positions for optimal head
and neck support.
16
Recline Adjustment
Rearward Facing Mode
(Child height 40cm-125cm/ Child weight
22.5kg)
see images
17
-
21
!
Please install the enhanced child restraint on the rear vehicle seat
and then put the child in the enhanced child restraint.
1. Press the harness adjustment button while pulling the shoulder
harnesses to the desired length (Pull from below the fixed shoulder
pads to lengthen).
17
2. Unlock the buckle of the harnesses by pressing the red button.
18
3. Fix the buckles on the both sides of seat to make placing the baby
more convenient.
19
4. Place the child into the enhanced child restraint and pass both arms
through the harnesses.
5. Engage the buckle. Please refer to
20
6. Pull down the adjustment webbing and adjust it to the proper length
to make sure your child is properly secured.
21
!
Always keep child secured in harness and properly tighten the
harness by removing any slack.
